airodump-ng doesn't see associated machines

Here is the process and results. I am not sure why this isn't working when a few day's ago it was. This is my network, I have full control over it and all the machines on it.

//Step 1 get wlan0 in monitor mode

root@kali:~# ifconfig wlan0 down
root@kali:~# iwconfig wlan0 mode monitor
root@kali:~# ifconfig wlan0 up
root@kali:~# iwconfig wlan0
wlan0     IEEE 802.11bgn  Mode:Monitor  Frequency:2.452 GHz  Tx-Power=20 dBm   
          Retry short limit:7   RTS thr:off   Fragment thr:off
          Power Management:off

root@kali:~# 


//step two create interface with airmon-ng

root@kali:~# airmon-ng start wlan0
Interface   Chipset     Driver

wlan0       Ralink RT2870/3070  rt2800usb - [phy0]
                (monitor mode enabled on mon0)

root@kali:~# 

//start airodump-ng to target my wifi
root@kali:~# airodump-ng mon0 

CH  5 ][ Elapsed: 2 mins ][ 2015-01-03 19:17  


 BSSID              PWR  Beacons    #Data, #/s  CH  MB   ENC  CIPHER AUTH ESSID

 <MAC Removed>  -17       75       14    0   1  54e  WPA2 CCMP   PSK  <ESSID Removed>  


//Attempt to target my wifi 
root@kali:~# airodump-ng mon0 -c 1 --bssid <MAC From Above>

It's at this point that I can see my wifi with all the correct info. However, NONE of the devices I have associated with my wifi appear? I have a phone, two kindles, a surface pro 3 and an xbox one all on my wifi. I would imagine at least one of them would appear in the associated devices output. Yet, nothing.

I am only about 10 feet from my router so I don't think it's a distance issue. Also, as I mentioned earlier, I tried this about a week ago and had success. I'm not sure what's different. Did I miss something?